AMORPHIC Commercial Water Softener Salt Meter

Flow since last salt recharge

Purchase the sensor for £75.

The red LED will light when more salt is required in the water softener, after recharging the water softener press the red button to reset.
The green LED will flash every 500ml simply to indicate the device is working correctly.
The internal dip switches can be adjusted for different water hardness. Turn the device off and back on to update the dip switch settings.

On your computer, tablet or mobile phone search for the WiFi network called AutoConnectAP
Type in the password provided on the sticky label
You may get a message not Internet Access - Click OK
Go to your Browser
Type in the website URL 192.168.4.1
Click on Connect to WiFi Network
Select your WiFi network name
Type in your WiFi password
Click Connect
You will now be able to view your device usage via this page, data will automatically start to show once 4 litres of water has been used.

Turn off the water at the water softener
Disconnect the cold water feed from the water softener outlet leading to the dishwasher
The flow meter has an arrow on it, connect the pipe provided to the flow meter end which shows to arrow pointing into the flow meter
Connect the pipe provided to the water softener outlet (If it does not fit check you have connected the correct end of the flow meter)
Mount the device on a wall or somewhere visible but not causing an obstruction
Connect the pipe from the dishwasher to the other end of the flow meter
Plug the device in
Turn the water back on

Use the following dip switch settings to set for your local area water hardness. Remove device cover to gain access to dip switches.